NEC MultiSync LCD1530V User Manual download pdf (Page 7)

English-6

Quick Start

To attach the MultiSync LCD monitor to your system, follow these

instructions:

1. Turn off the power to your computer.

2. For the PC: Connect the 15-pin mini D-SUB of the appropriate

signal cable to the connector of the display card in your system

(Figure A.1). Tighten all screws.

For the Mac: Connect the MultiSync LCD1530V Macintosh cable

adapter to the computer (Figure B.1). Attach the 15-pin mini D-SUB

end of the appropriate signal cable to the MultiSync LCD1530V

Macintosh cable adapter (Figure B.1). Tighten all screws.

Remove connector cover and cable cover on back of monitor

(Figure E.1).

3. Connect the 15-pin mini D-SUB of the video signal cable to the

appropriate connector on the back of the monitor (Figure C.1).

NOTE: Incorrect cable connections may result in irregular

operation, damage display quality/components of LCD

module and/or shorten the module’s life.

4. Connect one end of the power cord to the MultiSync LCD Series

monitor and the other end to the power outlet. Place the video signal

cable and AC power cord under the clips. (Figure C.1).

Replace connector cover and cable cover. (Figure E.1)

NOTE: Adjust the position of the cable under the clips to avoid

damage for cable or monitor.

5. Turn on the monitor (Figure D.1) and the computer.

6. To complete the setup of your MultiSync LCD monitor, use the

following OSM controls:

• Auto Adjust Contrast

• Auto Adjust

Refer to the Controls section of this User’s Manual for a full description

of these OSM controls.

NOTE: If you have any problems,please refer to the

Troubleshooting section of this User’s Manual.

NOTE: For easy removal of the cable cover or signal cable, place

the monitor face down. (Figure R.2)

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

No comments

NEC MultiSync LCD1530V User Manual Page 7