NEC NP40CM User Manual download pdf (Page 3)

ISSUED: 11-01-06 SHEET #: 055-9478-6 01-14-09

Visit the Peerless Web Site at www.peerlessmounts.com

3 of 8

For customer care call 1-800-729-0307 or 708-865-8870.

WOOD

JOIST

CEILING

Drill two 5/32" (4 mm) dia. holes to a minimum

depth of 2.5" (64 mm). Attach ceiling plate (G)

with two #14 x 2.5" (6 mm x 65 mm) wood

screws (F) as shown using 3/8" (10 mm) socket

wrench.

Skip to step 2.

IMPORTANT: Be sure to drill holes into the

joist CENTER!

For optional Cord Management,

install two spacers (H) between ceiling

plate (G) and ceiling.

Installation To Wood Joist Finished Ceilings,

Exposed Wood Joists, or Wood Beam Ceilings

WOOD

JOIST

CEILING

• Tighten wood screws (F) so that ceiling plate (G) is

firmly attached, but do not overtighten. Overtightening

can damage the screws, greatly reducing their holding

power.

• Never tighten in excess of 80 in • lb (9 N.M.).

• Make sure that mounting screws are anchored into the

center of the studs. The use of an "edge to edge" stud

finder is highly recommended.

WARNING

• It is the responsibility of the installer to verify that the

supporting surface will safely support the combined

load of all attached hardware and components.

WARNING

1 2 3 4 5 6 7 8

No comments

NEC NP40CM User Manual Page 3