NEC MultiSync LCD1810 User Manual download pdf (Page 14)

ALL RESET

MultiSync

LCD1810

™

monitor only

Selecting ALL RESET when D-SUB input is selected allows you to reset all

OSM control settings for the D-SUB input back to the factory settings.

Selecting ALL RESET when BNC input is selected allows you to reset all

OSM control settings for the BNC input back to the factory settings.

Individual settings can be reset by highlighting the control to be used and

pressing the RESET button.

MultiSync LCD

2010

™

monitor only

Selecting ALL RESET allows you to reset all OSM control settings back to the

factory settings. Individual settings can be reset by highlighting the control to

be used and pressing the RESET button.

Information

Indicates the current display resolution, frequency setting and type of

Sync signal the monitor is using.

NOTE: Mode Change should only be used if a resolution is not

recognized by the monitor. The user can change to the

appropriate resolution by selecting the Mode information

and selecting (increase or decrease) the corresponding

option.

NOTE: If the or button is pressed while TYPE is highlighted,

then Sync Type is switched between Separate Sync and Sync

On Green.

Controls cont.ols

78133813.wpc 10/28/99, 3:22 PM14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 79 80

No comments

NEC MultiSync LCD1810 User Manual Page 14