Nec 1080Xd User Manual download pdf (Page 182)

5-10 I/O Board Installation

6. Install the board in the slot.

7. Pivot the support bracket cover back into place and secure the pins in the

bracket ends (see Figure 5-8).

8. Replace the access cover.

! Insert the cover tabs into the slots in the chassis frame.

! Press the cover to secure it. Replace the screw (see Figure 5-7).

9. Carefully press all four rail latches (two on each side) and slowly slide the

chassis back into the cabinet (see Figure 5-9). Stop sliding if you feel

resistance and check for pinched or pulled cabling at the rear of the cabinet.

WARNING

Take care when releasing the latches and sliding the chassis

to avoid pinching your fingers.

A Two Rail Latches (right side shown)

Figure 5-9. Main Chassis Rail Latches

10. Carefully and slowly slide the chassis all the way into the cabinet. Replace

the six chassis screws (see Figure 5-6).

Note: If you need to connect any cables to the board,

do so before sliding the chassis all the way into the cabinet.

It might be easier to access board connectors with the

chassis forward.

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 215 216

No comments

Nec 1080Xd User Manual Page 182