NEC NP210 User Manual download pdf (Page 74)

6. Maintenance

 Replacing the Lamp

When the lamp reaches the end of its life, the LAMP indicator in the cabinet will blink red. Even though the lamp may

still be working, replace the lamp to maintain the optimal projector performance. After replacing the lamp, be sure to

clear the lamp hour meter. (→ page 63)

CAUTION

• DONOTTOUCHTHELAMPimmediatelyafterithasbeenused.Itwillbeextremelyhot.Turntheprojectoroff,

and then disconnect the power cable. Allow at least one hour for the lamp to cool before handling.

• DONOTREMOVEANYSCREWSexceptonelampcoverscrewandthreelamphousingscrews.Youcouldreceive

an electric shock.

• Donotbreaktheglassonthelamphousing.

Keep ﬁnger prints off the glass surface on the lamp housing. Leaving ﬁnger prints on the glass surface might cause

an unwanted shadow and poor picture quality.

• Theprojectorwillturnoffandgointostandbymodewhenyoucontinuetousetheprojectorforanother100hours

after the lamp has reached the end of its life. If this happens, be sure to replace the lamp. If you continue to use

the lamp after the lamp reaches the end of its life, the lamp bulb may shatter, and pieces of glass may be scattered

in the lamp case. Do not touch them as the pieces of glass may cause injury. If this happens, contact your NEC

dealer for lamp replacement.

*NOTE: This message will be displayed under the following conditions:

• foroneminuteaftertheprojectorhasbeenpoweredon

• whenthe (POWER)buttonontheprojectorcabinetorthePOWEROFFbuttonontheremotecontrolispressed

To turn off the message, press any button on the projector cabinet or the remote control.

Toreplacethelamp:

Optional lamp and tools needed for replacement:

• Replacementlamp:NP13LP

• Phillipsscrewdriverorequivalent

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 91 92

No comments

NEC NP210 User Manual Page 74