Nec AT-35 User Manual

Caller ID Handsfree Business Telephone AT-35 USER GUIDE DISCLAIMER The material contained herein is subject to change without prior not

INITIAL SETUP Setting the Flash Time The correct hookflash timing depends on the requirements of the PBX to which the telephone is connected. 1. En

BASIC OPERATION Making a Call using the Handset 1. Pick up the handset and wait for dial tone. 2. Dial the number you require. 3. Replace the hand

BASIC OPERATION Receiving a Call using the Handset 1. Pick up the handset when the phone rings. 2. Converse with your caller. 3. Replace the handse

FEATURES FLASH Key The FLASH key works the same as the hook switch of the phone. When the FLASH key is pressed during a conversation, it may termi

FEATURES Memory Redial The last 30 telephone numbers dialled (up to 21 digits each) are stored in the Outgoing Call Memory. To dial from the Outgo

FEATURES Temporarily Switching Pulse to Tone Dialling If your telephone set is connected to a Pulse dialling mode network, this feature allows you to

FEATURES One-Touch Dialling This telephone set is equipped with 10 one-touch dial memory keys for programming your most frequently dialled telephone

FEATURES Caller ID (CLI) This telephone set will display Caller ID (CLI) information received with incoming calls. The last 90 Caller ID numbers r

TROUBLESHOOTING Troubleshooting Guide Problem Solution No dial tone / Will not dial out • Check that the hookswitch is not depressed. • Check that

SPECIFICATIONS Caller ID receiver FSK (type I) or DTMF Caller ID information CLI number with date and time stamp Caller ID review, delete, dial bac

TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS... 2 LOCATION OF CONTROLS...

QUICK REFERENCE Feature Access Codes Operation: Dial Access Code + Option Code + # Feature Access Code Option Code Ring Tone ¿ 1 ¿ 1: Low Ton

IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, ele

LOCATION OF CONTROLS 3

LOCATION OF CONTROLS 1. Visual Ring Indicator/ Message Waiting Lamp Flashes to indicate an incoming call

INSTALLATION Package Contents Handset Telephone Base This User’s GuideHandset Curly Cord Telephone Line Cord Wall-Mount Screws and Ancho

INSTALLATION IMPORTANT: • Disconnect telephone line cord before removing battery cover to replace the batteries. Battery cover must be in place a

INSTALLATION Connecting an Additional Device An additional analogue device, such as an answering machine, facsimile machine or PC modem can be connec

INITIAL SETUP Selecting the Dialling Mode Set the dialling mode switch to either DP (Pulse) or MF (Tone) to select the signalling type. The correct