NEC Express5800/340Hb-R Setup Guide download pdf (Page 69)

Windows Setup 4-21

After the hard disk drive is formatted, the message about copying the NEC Express5800/ft

series system software to the system drive from the CD-ROM.

Wait about 5 minutes until copying is completed.

Formatting 3.07G

100 percent complete

Writing out file allocation table

Complete.

Calculating free space (this may take several minutes). . .

Complete.

Format complete.

System transferred

3,068.90 MB total disk space

114,688 bytes used by system

3,068.79 MB available on disk

4,096 bytes in each allocation unit.

785,606 allocation units available on disk.

Volume Serial Number is XXXX-XXXX

Copying necessary NEC Express5800/ft series system software to the

system drive... Approximately 5 minutes.

6. After finishing copying the software to the system drive, the following message will appear.

Remove the CD-ROM and press Enter. The NEC Express5800/ft series is restarted

automatically.

IMPORTANT: Make sure to remove the CD-ROM from the CD-ROM drive. If the

machine starts up with the CD-ROM inside, the system will be started up from the

CD-ROM and NEC EXPRESSBUILDER will be started.

Necessary NEC Express5800/ft series software has been copied.

Remove the CD-ROM from the CD-ROM drive, and press [ENTER] to finish.

The system will reboot from the Hard Disk Drive.

7. After the system is restarted, the following message will appear:

If you have an additional ft Update CD and wish to use it,

insert the CD-ROM into the CD-ROM drive.

Use an additional ft Update CD [Y,N]?

z If you have “NEC Express5800/ft series ft Update CD” handy, enter “Y”.

z If you do not have “NEC Express5800/ft series ft Update CD” handy and perform

installation using “NEC EXPRESSBUILDER” only, enter “N”.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 149 150

No comments

NEC Express5800/340Hb-R Setup Guide Page 69