NEC PD Comms Tool User's Guide download pdf (Page 26)

Commands - Security panel

The Security panel uses the security commands to read and write the current enable status of the security setting. If

currently enabled, the correct password must be supplied in order to disable the security setting when using Write.

Enabling Security will require that in order to use the display, the password be entered on the OSD using the IR remote

after AC power is applied.

Once unlocked, the display will remain unlocked until AC power is removed and returned.

The password can be set via the OSD. On some models it can also be set via the display’s web page.

Note: Do not forget the password! The password can only be reset be NEC service personnel. The default password is “0000”.

Lock Control is a legacy command used on older models.

26 | NEC PD COMMS TOOL - USER’S GUIDE

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 61 62

No comments

NEC PD Comms Tool User's Guide Page 26