NEC NP210 User Manual download pdf (Page 77)

7. Appendix

1 Troubleshooting

This section helps you resolve problems you may encounter while setting up or using the projector.

Indicator Messages

Power Indicator

Indicator Condition ProjectorCondition Note

Off

The power cable is unplugged.

–

Blinking light Green 0.5 sec On,

0.5 sec Off

The projector is getting ready to turn on. Wait for a moment.

2.5 sec On,

0.5 sec Off

Off Timer is enabled.

–

Steady light Green The projector is turned on.

–

Orange [NORMAL] is selected for [STANDBY MODE]

–

Red [POWER-SAVING] is selected for [STANDBY

MODE]

–

Status Indicator

Indicator Condition ProjectorCondition Note

Off

Normal or Standby ([POWER-SAVING] for

[STANDBY MODE])

–

Blinking light Red 1 cycle (0.5 sec

On, 2.5 sec Off)

Lamp cover error or lamp housing error Replace the lamp cover or lamp housing cor-

rectly.

2 cycle (0.5 sec

On, 0.5 sec Off)

Temperature error The projector is overheated. Move the projector to

a cooler location.

4 cycle (0.5 sec

On, 0.5 sec Off)

Fan error Fans will not work correctly.

6 cycle (0.5 sec

On, 0.5 sec Off)

Lamp error Lamp fails to light. Wait a full minute and then

turn on again.

Green Re-firing the lamp (The projector is cooling

down.)

The projector is re-ﬁring.

Wait for a moment.

Steady light

Green

Standby ([NORMAL] for [STANDBY MODE])

–

Orange Cabinet button is locked You have pressed cabinet button when Cabinet

Button is locked.

CONTROL ID error Remote control ID and projector ID are not

matched.

Lamp Indicator

Indicator Condition ProjectorCondition Note

Off Normal

–

Blinking light Red Lamp has reached its end of life. Lamp replace-

ment message will be displayed.

Replace the lamp.

Steady light Red Lamp has been used beyond its limit. The projec-

tor will not turn on until the lamp is replaced.

Replace the lamp.

Green [ECO MODE] is set to [ON]

–

Over-TemperatureProtection

If the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the lamp

with the STATUS indicator blinking (2-cycle On and Off.)

Should this happen, do the following:

• Unplugthepowercableafterthecoolingfansstop.

• Movetheprojectortoacoolerlocationiftheroomwhereyouarepresentingisparticularlytoowarm.

• Cleantheventilationholesiftheyarecloggedwithdust.

• Waitabout60minutesuntiltheinsideoftheprojectorbecomescoolenough.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 91 92

Comments to this Manuals

No comments

NEC NP210 User Manual Page 77

Comments to this Manuals

Related products and manuals for Data projectors NEC NP210