NEC NP400 User Manual download pdf (Page 24)

2. Installation and Connections

When Viewing a DVI Digital Signal

To project a DVI digital signal, be sure to connect the PC and the projector using a DVI cable (not supplied) before

turning on your PC or projector. Turn on the projector ﬁrst and select Computer 2 (Digital) from the source menu before

turning on your PC.

Failure to do so may not activate the digital output of the graphics card resulting in no picture being displayed. Should

this happen, restart your PC.

Do not disconnect the DVI cable while the projector is running. If the signal cable has been disconnected and then

re-connected, an image may not be correctly displayed. Should this happen, restart your PC.

NOTE:

• Use a DVI cable or the one compliant with the DDWG (Digital Display Working Group) DVI (Digital Visual Interface) revision 1.0

standard. The DVI cable should be within 5 m (196") long. Both single and dual types of DVI cable can be used.

• The DVI (DIGITAL) connector accepts VGA (640x480), SVGA (800x600), 1152x864, XGA (1024x768), WXGA (1280x800 @ up

to 60Hz), and SXGA (1280x1024 @ up to 60Hz).

COMPUTER 2 (DVI-I) IN

PHONE

AUDIO IN

Audio cable (not supplied)

IBM PC or Compatibles (Desktop type)

or Macintosh (Desktop type)

DVI cable (not supplied)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 98 99

No comments

NEC NP400 User Manual Page 24