NEC NP400 User Manual download pdf (Page 42)

3. Projecting an Image (Basic Operation)

 After Use

Preparation: Make sure that the projector is turned off.

1. Unplug the power cable.

2. Disconnect any other cables.

3. Retract adjustable tilt foot if extended.

4. Cover the lens with the lens cap.

5. Put the projector and accessories in the supplied soft case.

Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens from

damage.

NOTE: When placing the projector in the soft case, retract the tilt foot and the rear feet. Failure to do so may case damage to the

projector.

CAUTION:

Use caution when putting the projector in the soft case immediately after the projector has been operating. The

projector cabinet is hot.

Insert the projector with the lens

facing upward

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 98 99

No comments

NEC NP400 User Manual Page 42