NEC 77F User Manual download pdf (Page 5)

Quick Start

Figure A.1

To attach the MultiSync

monitor to your system, follow these

instructions:

1. Turn off the power to your computer.

2. If necessary, install the display card into your system. For more information,

refer to the display card manual.

3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the

connector of the display card in your system (Figure A.1). Tighten all screws.

For the Mac: Connect the Macintosh cable adapter (not included) to the

monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini

D-SUB end of the captive signal cable to the Macintosh cable adapter on

the computer (Figure B.1). Tighten all screws.

NOTE: To obtain the Macintosh cable adapter, call NEC-Mitsubishi Electronics

Display of America, Inc. at (800) 632-4662.

4. Connect one end of the power cord to the MultiSync monitor and the other

end to the power outlet (Figure C.1).

5. Turn on the monitor (Figure D.1) and the computer.

NOTE: For download information on the Windows

95/98/2000/XP INF file

for your MultiSync monitor, refer to the References section of this User’s

Manual.

NOTE: If you have any problems, please refer to the Troubleshooting section of

this User’s Manual.

Captive Signal Cable

15-pin mini D-SUB

MS77F97F112701.p65 11/27/01, 3:15 PM5

1 2 3 4 5 6 7 8 9 10 ... 31 32

No comments

NEC 77F User Manual Page 5