Nec AccuSync 70 User Manual download pdf (Page 7)

Quick Start –continued

Figure A.1

To attach the AccuSync monitor to your system, follow these

instructions:

1. Turn off the power to your computer.

2. If necessary, install the display card into your system. For more information,

refer to the display card manual.

3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the

connector of the display card in your system (Figure A.1). Tighten all screws.

For the Mac: Connect the Macintosh cable adapter (not included) to the

monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini

D-SUB end of the captive signal cable to the Macintosh cable adapter on

the computer (Figure B.1). Tighten all screws.

NOTE: To obtain the Macintosh cable adapter, call NEC-Mitsubishi Electronics

Display of America, Inc. at (800) 820-1230.

4. Connect one end of the power cord to the AccuSync monitor and the other

end to the power outlet (Figure C.1).

5. Turn on the monitor (Figure D.1) and the computer.

NOTE: For download information on the Windows

95/98/2000 INF file for

your AccuSync monitor, refer to the References section of this User’s Manual.

NOTE: If you have any problems, please refer to the Troubleshooting section of

this User’s Manual.

Captive Signal Cable

15-pin mini D-SUB

AS507090.wpc 5/14/01, 11:22 AM7

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

No comments

Nec AccuSync 70 User Manual Page 7