NEC Express 320Lc-R User Manual download pdf (Page 107)

Procedures after Completion of Installation 5-5

IMPORTANT:

 If the community name is changed, the community of NEC ESMPRO

Agent is changed and registered by starting from [Control Panel]. To

change the community to another and register it, use the [SNMP

Community] list box in the [General] tab.

 To allow NEC ESMPRO Agent to receive SNMP packets sent from NEC

ESMPRO Manager, set the send community name in NEC ESMPRO

Manager to be the same as that accepted by the SNMP Service in NEC

ESMPRO Agent.

7. Terminate the network setup.

IMPORTANT:

 If the SNMP Service is added after adaptation of the service pack in

installation of OS, adapt the service pack again. If not, the SNMP Service

may not operate correctly. This then disables NEC ESMPRO Agent to be

operated.

 The SNMP Service is required for operating NEC ESMPRO Agent. If the

SNMP Service is deleted after the installation of NEC ESMPRO Agent,

install the SNMP Service and then reinstall NEC ESMPRO Agent.

 Some software products provided by other vendors use the SNMP Service.

If the SNMP Service and NEC ESMPRO Agent are installed in the system

in which such software as above is installed, it may be impossible to start

NEC ESMPRO Agent services. If so, delete the SNMP Service once and

install the service again. After which, reinstall NEC ESMPRO Agent and the

other vendor's software.

System Update

To install NEC ESMPRO Agent, necipmi.sys needs to be installed in advance. For the installation of

necipmi.sys, use the NEC EXPRESSBUILDER CD-ROM shipped with the system to update the

system (see page 6-9).

If necipmi.sys is not installed yet, the message shown below appears and the setup of NEC

ESMPRO Agent is suspended.

"NEC ESMPRO Agent requires the following file.

Please update NEC Express5800 system before installing NEC ESMPRO Agent.

necipmi.sys"

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 144 145

No comments

NEC Express 320Lc-R User Manual Page 107