NEC Express5800/340Hb-R Setup Guide download pdf (Page 145)

Troubleshooting 6-21

Troubleshootin

This section describes w

Problems with NE

hat you should do when a trouble occurs in the product.

C EXPRESSBUILDER

When the server is not b the following:

 EC EXPRESSBUILDER CD-ROM during POST and restart the server?

and restart the



→ The boot device order may be specified with the BIOS setup utility of the server. Use the

t the system from the CD-ROM

When SSBUILDER is in progress, the following message

appea rror and take the appropriate corrective action according

t he table below.

Cause and Remedy

ooted from the NEC EXPRESSBUILDER CD-ROM, check

Did you set the N

→ If you do not set the NEC EXPRESSBUILDER CD-ROM during POST

server, an error message will appear or the OS will boot.

Is BIOS configuration correct?

BIOS setup utility to change the boot device order to boo

drive first.

an error occurs while the NEC EXPRE

rs. After this message appears, check the e

o the error codes listed in t

Message

This machine i

DER on the compliant

s not supported.

This NEC EXPRESSBUILDER version is

not designed for this server. Execute the

NEC EXPRESSBUIL

server.

NvRA

vRAM) is not acceptable.

M access error

An access to the nonvolatile memory

Hard disk access error The hard disk is not connected or it is failed.

Check whether the hard disk is correctly

connected.

An error message will also be displayed when an error was detected during system diagnosis. Take a

note or print the error message displayed, and contact your sales agent.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150

Comments to this Manuals

No comments

NEC Express5800/340Hb-R Setup Guide Page 145

Comments to this Manuals

Related products and manuals for System management software NEC Express5800/340Hb-R