NEC NP216 User Manual download pdf (Page 36)

3. Projecting an Image (Basic Operation)

7 Turning off the Projector

Toturnofftheprojector:

1. First, press the (POWER) button on the projector

cabinet or the POWER OFF button on the remote con-

trol.

The [POWER OFF / ARE YOU SURE? /CARBON SAV-

INGS- SESSION X.XXX[g-CO2]] message will appear.

2. Secondly, press the ENTER button or press the

(POWER) or the POWER OFF button again.

The lamp will turn off and the projector will go into standby

mode. When in standby mode, the POWER indicator will

light orange and the STATUS indicator will light green when

[NORMAL] is selected for [STANDBY MODE].

Immediately after turning on the projector and displaying an

image, you cannot turn off the projector for 60 seconds.

3. Finally, unplug the power cable.

The POWER indicator will go out.

CAUTION:

Parts of the projector may become temporarily heated if the AC power supply is disconnected either during normal

projector operation or during cooling fan operation. Use caution when picking up the projector.

＋

Power On Standby

Steady green light Steady orange light

NOTE:

• Donotturnoffthepowerfor60secondsimmediatelyafterturningitonanddisplayinganimage.

• DonotdisconnecttheACpowersupplytotheprojectorwithin10secondsofmakingadjustmentorsettingchangesandclosing

themenu.Doingsocancauselossofadjustmentsandsettings.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 96 97

No comments

NEC NP216 User Manual Page 36