Nec MT 1020G /820G User Manual download pdf (Page 12)

E – 12

BMenu Button

Use this button to call up the On-Screen Menu so you can

adjust and set the image. After you press this button, it

will light up. During this time you can use the mouse

pointer and right / left click buttons to make menu selec-

tions. If no buttons are pressed within 10 seconds while it

illuminates, the light goes out. To return to the main menu

from a sub menu, press this button again.

CMouse Pointer Buttons

Works as a mouse for your projected computer image.

This button is also used to adjust position.

These buttons select the submenu you want to adjust.

(See page E-23.)

After you make your on-screen menu selection, use this

button to adjust the level up or down. (See page E-23.)

DRight Click Button

Press this button to exit "Menus" or "Position."

EFreeze Button

This button will freeze a picture. Press again to resume

motion.

FPosition Button

When the picture is magnified, press this button to acti-

vate the mouse buttons that you can use to reposition the

image in eight directions. When you're finished, the "Po-

sition" button will remain lit for 10 seconds.

NOTE: When you are adjusting Position, the Mouse Pointer button is

used to move the picture.

GPicture Mute Button

This button turns off the image for a short period of time.

Press again to restore the image.

HMagnify/Reduce Button

Use the (+) or (–) button to adjust the image size up to

400%.

IFocus Button

Press the (+) or (–) button to adjust the focus.

JZoom Button

Press the (+) button to zoom in and the (–) button to zoom

out.

KRemote Jack

Connect your remote control cable here for for wired

operation.

NOTE: You cannot use Menu and Position at the same time.

OFF ON

VIDEO

RGB 1

R-CLICK

LASER

ZOOM FOCUS

S-VIDEO VOLUME

–

POSITION

MAGNIFY

REDUCE

PIC-MUTE FREEZE

RGB 2

–

POWER

Remote Control Precautions

• Do not look into the laser pointer while it is on.

• Do not point the laser beam at a person.

• When the cable is connected to the remote control, it will

not work wirelessly.

• Handle the remote control carefully.

• If the remote control gets wet, wipe it dry immediately.

• Avoid excessive heat and humidity.

•

If you will not be using the remote control for a long time,

remove the batteries.

• Do not mix new and old or different types of batteries.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 37 38

Comments to this Manuals

No comments

Nec MT 1020G /820G User Manual Page 12

Comments to this Manuals

Related products and manuals for Projectors Nec MT 1020G /820G