Nec MT830 User Manual download pdf (Page 23)

E-22

Connecting Your PC Or Macintosh

Computer

Connecting your PC or Macintosh computer to your MultiSync

MT830 (SVGA)/1030 (XGA) Projector will enable you to

project your computer's screen image for an impressive presen-

tation. All of these following display standards are supported:

To connect to a PC, Macintosh or computer equipped with an

XGA/SVGA /VGA adapter or compatible graphics adapter,

simply:

1. Turn off the power to your projector and computer.

2. If your PC does not support XGA/SVGA/VGA you will need

to install an XGA/SVGA/VGA graphics board. Consult your

computer's owner's manual for your XGA/SVGA/VGA con-

figuration. If you need to install a new board, see the manual

that comes with your new graphics board for installation

instructions.

3. Use the signal cable that's supplied to connect your PC or

Macintosh computer to the projector. For a Macintosh, use

the supplied pin adapter to connect to your Mac's video port.

4. Turn on the projector and the computer.

5. If the projector goes blank after a period of inactivity, it may

be caused by a screen saver installed on the computer you've

connected to the projector.

When using a Macintosh with the MT830/1030, set the DIP

switches of the supplied pin adapter according to your resolu-

tion. After setting, restart your Macintosh.

See the following pages for setting of the DIP switches.

•

When using with a Macintosh, XGA/VGA/SVGA is recom-

mended if your Macintosh supports this mode.

• When using with a Macintosh PowerBook, output may not

be set to 10242768 unless “mirroring” is off on your

PowerBook. Refer to owner’s manual supplied with your

Macintosh computer for mirroring.

NOTE: A Video Adapter cable manufactured by Apple Com-

puter is needed for a PowerBook which does not have a mini D-

Sub 15-pin connector.

VGA 6402480 for graphics VGA 6402400 for graphics

VGA 6402350 for graphics VGA 7202400 for text

VGA 7202350 for text SuperVGA 8002600

Macintosh at 6402480 Macintosh at 8322624

XGA10242768 Macintosh at 10242768

SXGA128021024 (AccuBlend)

Settings for Monitor Mode

Number of DIP switch

Monitor size

15” multi-scan mode /16”–13”

17” multi-scan mode /19”–13”

19” multi-scan mode /21”–13”

13” fixed mode /6402480

VGA/SVGA mode

16” fixed mode /8322624

19” fixed mode /10242768

S2 S3 S4

NOTE: For settings other than display modes supported by your

Macintosh and MT830/1030, use of the DIP switch may bounce a

image slightly or may display nothing. If this happens, set the DIP

switch to the 13” fixed mode and then restart your Macintosh. After

that, restore to a displayable mode and then restart the Macintosh

again.

Make sure that the MT830/1030 and your Macintosh are connected

with the pin adapter and the supplied signal cable (mini D-Sub 15-

pin connector) and then restart your Macintosh.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

Comments to this Manuals

No comments

Nec MT830 User Manual Page 23

Comments to this Manuals

Related products and manuals for Projectors Nec MT830