Nec NP2250 User Manual download pdf (Page 36)

2. Installation and Connections

Connecting the Supplied Power Cable

Connect the supplied power cable to the projector.

First connect the supplied power cable’s three-pin plug to the AC IN of the projector, and then connect the other

plug of the supplied power cable in the wall outlet.

LAM

STATUS

POWER

SOU

RCE

AUTO ADJUST

D REFORM

USB

LENS SHIFT

LEFT

RIGHT

DOWN

WIRELESS

Make sure that the prongs are fully

inserted into both the AC IN and the

wall outlet.

To wall outlet

HIF

LEF

NOTE: To turn off the AC power supply when the projector is powered on, use a power strip equipped with a switch and a breaker.

CAUTION:

Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become heated

while the projector is turned on and immediately after the projector is turned off.

CAUTION:

Do not unplug the power cable from the wall outlet or projector when the projector is powered on. Doing so can

cause damage to the AC IN connector of the projector and (or) the prong plug of the power cable.

About Direct Power Off

The projector has a feature called “Direct Power Off”. This feature allows the projector to be turned off (even when

projecting an image) using the Main Power Switch or disconnecting the AC power supply.

NOTE: Before using Direct Power Off, be sure to allow at least 20 minutes immediately after turning on the projector and starting

to display an image.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 182 183

No comments

Nec NP2250 User Manual Page 36