NEC MultiSync FP1350X User Manual download pdf (Page 5)

Quick Start

To attach the MultiSync

FP1350X

™

monitor to your system, follow

these instructions:

1. Turn off the power to your computer.

2. For the PC with DVI digital output: Connect the DVI-D to DVI-D cable to the connector

of the display card in your system (Figure A.1). Tighten all screws.

For the PC with DFP digital output: Connect the DVI to DFP Adapter (not included) to

the computer (Figure A.2). Attach the DVI signal cable to the DVI to DFP Adapter.

Tighten all screws.

For the PC with Analog output: Connect the 15-pin mini D-SUB to DVI signal cable to

the connector of the display card in your system (Figure A.3).

To connect a secondary PC with analog output: Connect the 15-pin mini D-SUB signal

cable (not included) to the connector of the display card in your system.

For the MAC: Connect the MultiSync Macintosh cable adapter (not included) to the

computer, then attach the 15-pin mini D-SUB signal cable to the MultiSync Macintosh

cable adapter (Figure B.1).

NOTE: Some Macintosh systems do not require a Macintosh cable adapter.

NOTE: To obtain the MultiSync Macintosh cable adapter or DVI to DFP adapter call

NEC Technologies at (800) 820-1230

NOTE: Incorrect cable connections may result in irregular operation or damage

display components

3. Connect one end of the power cord to the MultiSync FP

1350X monitor and the other

end to the power outlet (Figure C.1).

4. Turn on the monitor (Figure D.1) and the computer.

NOTE: For download information on the Windows

95/98 INF file for your MultiSync

1350X monitor, refer to the References section of this User’s Manual.

NOTE: If you have any problems, please refer to the Troubleshooting section of this

User’s Manual.

7A811011.WPC 5/18/00, 12:26 PM5

1 2 3 4 5 6 7 8 9 10 ... 67 68

No comments

NEC MultiSync FP1350X User Manual Page 5