Nec NP2250 User Manual download pdf (Page 140)

126

6. Using On-Screen Menu

[OPTIONS]

Setting Auto Adjust [AUTO ADJUST]

This feature sets the Auto Adjust mode so that the RGB image can be automatically or manually adjusted for noise

and stability. You can automatically make adjustment in two ways: [NORMAL] and [FINE].

OFF ........................ The RGB image will not be automatically adjusted.

You can manually optimize the RGB image.

NORMAL ................ Default setting. The RGB image will be automatically adjusted. Normally select this option.

FINE ....................... Select this option if ﬁne adjustment is needed. It takes more time to switch to the source than when

[NORMAL] is selected.

Enabling Auto Power On [AUTO POWER ON (AC)]

Turns the projector on automatically when the power cable is inserted into an active power outlet and the main pow-

er switch is turned on. This eliminates the need to always use the POWER (ON/STANDBY) button on the remote

control or projector cabinet.

To use the AUTO POWER ON (AC) function, you must ﬁrst press the main power switch to the position “On” before

plugging in the power cable.

Turning On the Projector By Applying RGB Signal [AUTO POWER ON(COMP1/2)]

When the projector is in standby condition, applying an RGB signal from a computer connected to the COMPUTER

1 IN or the COMPUTER 2 IN connector will power on the projector and simultaneously project the computer’s im-

age.

This functionality eliminates the need to always use the POWER button on the remote control or the projector cabi-

net to power on the projector.

To use this function, ﬁrst connect a computer to the projector and the projector to an active AC input.

OFF ........................ This feature is disabled.

COMPUTER 1 ........ Applying an RGB signal from a computer connected to the COMPUTER 1 IN input will power on the pro-

jector and simultaneously project the computer’s image.

COMPUTER 2 ........ Applying an RGB signal from a computer connected to the COMPUTER 2 IN input will power on the pro-

jector and simultaneously project the computer’s image.

NOTE:

• Disconnecting an RGB signal from the computer will not power off the projector. We recommend using this function in combi-

nation of the AUTO POWER OFF function.

• This function will not be available under the following conditions:

- when a component signal is applied to the COMPUTER 1 or 2 IN connector

- when a Sync on Green RGB signal or composite sync signal is applied

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 182 183

No comments

Nec NP2250 User Manual Page 140