NEC Express5800/320Fc Manual download pdf (Page 32)

Post-Installation Tasks and Considerations

2-16 Express5800/ftServer: System Administrator’s Guide for the Linux Operating System

Post-Installation Tasks and Considerations

After installing the operating system and Express Builder consider the following topics.

•

‘‘Default Configuration Notes”

•

‘‘Configuring the Network”

•

‘‘Adding Fault-Tolerant Utilities to PATH”

Default Configuration Notes

After installation, the default installed system should appear as described in ‘‘Default

System Setup’’ on page 2-3. The following notes apply to the default system

configuration.

NOTES

1. After you upgrade or restore the Linux operating

system and Express Builder distributions as described

in this chapter, you may also need to separately install

optional packages using the rpm command.

2. The system disk pair was created as a RAID-1

mirrored drive set on drives sda and sdd. Each drive

is bootable and configured identically to the other.

3. After installation, the kudzu, haldaemon, and

microcode_ctl services are disabled. Do not enable

these services.

Configuring the Network

Perform the following tasks to configure the system for operating on a network.

1. Issue the following command to launch the Linux graphical network-configuration

program:

# system-config-network

2. In the graphical network configuration tool, specify the network hostname for your

system.

See the section on adding hosts in the Red Hat Enterprise Linux 4 System

Administration Guide for detailed information about configuring networks.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 155 156

No comments

NEC Express5800/320Fc Manual Page 32