Nec NP40 User Manual download pdf (Page 25)

SOURCE

AUTO

ADJ.

ON/STAND BY

FOCUS

LAMP

STATUS

POWER

SELECT

SOURCE

AUTO

ADJ.

ON/STAND BY

FOCUS

LAMP

STATUS

POWER

SELECT

EXIT

PAGE

OFF

POWER

PIC-MUTE

DOWN

FOCUS

ENTER

3. Projecting an Image (Basic Operation)

Note on Startup screen (Menu Language Select screen)

When you  rst turn on the projector, you will get the Startup menu. The menu gives you the opportunity to select

the menu in one of the nine languages.

To select a menu language, follow these steps:

1. Use the SELECT ▲ or ▼ button to select one of the

nine languages from the menu.

2. Press the ENTER button to execute the selection.

After this has been done, you can proceed to the menu op-

eration.

If you want, you can select the menu language later. (→ [Lan-

guage] on page

41)

NOTE: Immediately after turning on the projector, screen ﬂ icker may occur. This is normal. Wait 3 to 5 minutes until the lamp

lighting is stabilized.

When the [Lamp mode] is set to [Eco], the LAMP indicator will light green.

If one of the following things happens, the projector will not turn on.

• If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this

condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's in-

ternal components to cool down.

• When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.

• If the lamp fails to light, and if the STATUS indicator  ashes on and off in a cycle of six times, wait a full minute

and then turn on the power.

ENTER

EXIT

PAGE

OFF

POWER

PIC-MUTE

DOWN

FOCUS

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 73 74

Comments to this Manuals

No comments

Nec NP40 User Manual Page 25

Comments to this Manuals

Related products and manuals for Projectors Nec NP40