NEC Express5800/R110d-1E Installation Guide download pdf (Page 58)

8.5 BMC Configuration

♦BMC Configuration tool

Among the BMC configuration information tools there are some tools which cannot be use d to setup NEC ES

MPRO Manager.

 NEC MWA Agent cannot be used.

 If NEC MWA is stored in the EX PRESSBUILDER DVD-ROM, [A setup of a s ystem management] stored in the

same EXPRESSBUILDER DVD-ROM cannot be used.

 The Console-less function of th e EXPRESSBUILDER can not be used when NEC MWA is sto red in the s

ame EXPRESSBUILDER DVD-ROM.

♦In case of exchange of Management PC

If a Man agement PC as an alert receiver has been exchanged, register the m anaged server's BMC configurati

on information again even when the IP address of the Management PC remains unchanged. Otherwise, the B

MC may fail t o recognize the alert receiver.

♦Function "Obtain an IP Address automatically (DHCP)"

The managed server included the BMC t hat uses a Management LA N port suppor ts the function "Obt ain an I

P Address automatically (DHCP)".

1. Following version of NEC E SMPRO Manager modules supports the se tting of the fu nction.

Managed server DianaScope

DianaScope Manager Ver.1.07.01 or later

DianaScope PXE Service Ver.1.02.00 or later

DianaScope Agent Ver.2.03.05 or later

The managed serv er that integr ates EXPRESSSCOPE

Engine series. DianaScope Manager Ver.1.07.01 or l a

ter

DianaScope Configuration Ver.1.02 or l ater

DianaScope Manager Ver.1.11.00 or later

DianaScope PXE Service Ver.1.03.00 or later *1

DianaScope Agent Ver.2.06.00 or later

The managed server installed Advanced Remote Mana

gement Card or ft Remote Management Card.

DianaScope Configuration Ver.1.02 or l ater

*1 Not Support the mana ged server i nstalled ft Remote Management Card.

When you use the module that does not sup port the setting of th e function "Obtain an IP Address automatical

ly (DHCP)" for the man aged server that s upports the fu nction, note followings :

- If DianaScope Agent does not support the setting of the function, the DianaScope Agent always set

[disable] for the function when it registers the BMC configuration. The DianaScope Agent also set [disable]

when it writes the BMC configuration information file.

- If DianaScope Configuration does not support the setting of the function, the DianaScope Configuration

always set [disable] for the function when it writes the BMC configuration information file.

- If [System Management] tool on EXPRESSBUILDER does not support the setting of the function, the tool

always set [disable] for the function when it registers the BMC configuration. The tool also set [disable]

when it writes the BMC configuration information file.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 73 74

No comments

NEC Express5800/R110d-1E Installation Guide Page 58