NEC Express5800/R110d-1E Installation Guide download pdf (Page 59)

- If remote console feature of EXPRESSBUILDER does not support the setting of the function, the tool

always set "disable" for the function when it registers the BMC configuration.

- If NEC ESMPRO Manager does not support the setting of the function, the NEC ESMPRO Manager cannot

set disable for the function nor change IP address when DianaScope Agent support the setting of the

function and the function has been set enable.

2. Advanced Remote Management Card and ft Remote Management Card

If the managed server has been installed Advanced Remote Management Card or ft Remote Management

Card, the BMC may not immediately obtain the IP address after NEC ESMPRO Manager PXE Se rvice c

onfigures the BMC to obtain the IP address by the DHCP. Turn the managed server AC-OFF and then A

C-ON because the BMC tr y to obt ain the IP address whenever the managed server is turn ed AC-ON.

♦Port that BMC uses

In case that Linux on the managed server uses port 623, NEC ESMP RO Manager cannot communicate with t

he BMC th at uses st andard LAN p ort.

Perform following settings:

1. Add the following entries in services files (/etc/services) to reserv e port 623.

asf-rmcp 623/tcp ASF Remote Management and Control Protocol

asf-rmcp 623/udp ASF Remote Management and Control Protocol

2. Reboot the O S.

♦Initialization of the BMC Configuration Information setting]

When you set [Default value] on the BM C Configuration Information with DianaScope Agent or NEC ESMPR

O Agent Extension, or create New Configuration with [System Management Tool] started from E XPRESSBUILD

ER DVD-ROM, each items of the BMC C onfiguration Information are initia lized.

If the managed server integrates EXPRESSSCOPE Engine series, Advanced Remote Management Card or ft

Remote Management Card, following items for BMC W eb server are also initiali zed because th ey are shared

with BMC C onfiguration Information:

DHCP Configuration

IP Address

Subnet Mask

Default Gateway

How to s et the W eb server is follo wing:

 Select [System Management Tool]. on [Tool]. started from E XPRESSBUILDER DVD-ROM, and then s elect

[Web server of BMC].

 Login to W eb server of the BMC, and th en select [Configuration] – [Network].

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 73 74

No comments

NEC Express5800/R110d-1E Installation Guide Page 59