Nec MT600 User Manual download pdf (Page 20)

CAUTION

• Only clean the outside of the filter with a vacuum cleaner.

• Do not clean inside the projector where the filter is positioned and the caution

label is placed.

• Do not attempt to operate the projector without a filter.

• Your LCD projector will not operate unless the filter is installed correctly.

• Do not put the LCD projector on end except for lamp and/or air filter

replacemant.

MAINTENANCE

–

REMOTE

CONTROL

PC

CONTROL

S-VIDEO

INPUT

VIDEO



L/MONO R



AUDIO INPUT

VIDEO

INPUT

External

Monitor

On/Off

AUDIO

INPUT

AUDIO

OUTPUT

DC12V/400mA



OUTPUT

RGB

RGB THROUGHPUT



4. Left Channel/Mono Audio Input Jack This is your left channel audio input for stereo

sound coming from video equipment or audio system. It also serves as the mono audio

input for S-Video input.

5. Right Channel Audio Input Jack This is your right channel audio input for stereo sound.

6. Video Input Connect a VCR or laser disk player here to project the video.

7. RGB-Input/Through-Put Connectors Attach either end of the MultiCable to computer

or document camera, and then attach the other end to either of these two connectors. You

can then use the remaining connector, if you wish, to output the video signal to a monitor.

(If you do use a second monitor, turn the monitor switch

Remote Control Battery Installation

1. Press firmly on point “A” and slide the battery cover off.

2. Remove all four old batteries and install new ones (AAA). Ensure that you have the

batteries’ polarity (+/-) aligned correctly.

3. Slip the cover back over the batteries until it snaps into place.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Comments to this Manuals

No comments

Nec MT600 User Manual Page 20

Comments to this Manuals

Related products and manuals for Projectors Nec MT600