NEC Express5800/340Hb-R User's Guide download pdf (Page 66)

2-30 General Description

Power ON

To power on NEC Express5800/ft series, press the POWER switch located on the front panel.

Follow the steps below to turn on the power.

1. Power on the display unit and other peripheral devices connected to the server.

CHECK: If the power cord is connected to a power controller like a UPS, make

sure that it is powered on.

NOTE: When NEC Express5800/ft series is powered on, BMCs between the two

PCI modules are synchronized. (The BMC status LED on the secondary module

blinks.) See Chapter 2 “LEDs” for details of the BMC status LED.

2. Remove the front bezel.

3. Confirm that the BMC status LED on both PCI modules are off and press the POWER

switch which illuminates green and located on the front panel.

After a while, the "NEC" logo will appear on the screen.

POWER switches* (LEDs)

* You can only use a power

switch whose LED is on.

IMPORTANT:

 Do not turn off the power before the "NEC" logo appears.

 Before powering on, make sure that the BMC status LED on the both PCI

modules are off and then press the power switch.

While the "NEC" logo is displayed on the screen, NEC Express5800/ft series is

performing a power-on self test (POST) to check itself. For details, see "Power-On Self

Test (POST)" described later in this manual. Upon the completion of POST, Windows

Server 2003 will start.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 311 312

No comments

NEC Express5800/340Hb-R User's Guide Page 66