NEC NP-UM351WI-TM User Manual download pdf (Page 102)

5. Using On-Screen Menu

SelectingCommunicationSpeed[COMMUNICATIONSPEED]

ThisfeaturesetsthebaudrateofthePCControlport(D-Sub9P).Itsupportsdataratesfrom4800to38400bps.The

defaultis38400bps.Selecttheappropriatebaudrateforyourequipmenttobeconnected(dependingontheequip-

ment,alowerbaudratemayberecommendedforlongcableruns).

NOTE:Yourselectedcommunicationspeedwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

SettingIDtotheProjector[CONTROLID]

YoucanoperatemultipleprojectorsseparatelyandindependentlywiththesingleremotecontrolthathastheCONTROL

IDfunction.IfyouassignthesameIDtoalltheprojectors,youcanconvenientlyoperatealltheprojectorstogether

usingthesingleremotecontrol.Todoso,youhavetoassignanIDnumbertoeachprojector.

CONTROL ID NUMBER ��Select a number from 1 to 254 you wish to assign to your projector�

CONTROL ID ��Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID set-

ting�

NOTE:

• When[ON]isselectedfor[CONTROLID],theprojectorcannotbeoperatedbyusingtheremotecontrolthatdoesnotsupport

theCONTROLIDfunction.(Inthiscasethebuttonsontheprojectorcabinetcanbeused.)

• Yoursettingwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

• PressingandholdingtheENTERbuttonontheprojectorcabinetfor10secondswilldisplaythemenuforcancelingtheControl

ID.

AssigningorChangingtheControlID

1. Turn on the projector.

2. PresstheIDSETbuttonontheremotecontrol.

 TheCONTROLIDscreenwillbedisplayed.

 IftheprojectorcanbeoperatedwiththecurrentremotecontrolID,the[ACTIVE]willbedisplayed.Iftheprojector

cannotbeoperatedwiththecurrentremotecontrolID,the[INACTIVE]willbedisplayed.Tooperatetheinactive

projector,assignthecontrolIDusedfortheprojectorbyusingthefollowingprocedure(Step3).

3. PressoneofnumerickeypadbuttonswhilepressingandholdingtheIDSET

button on the remote control.

Example:

 Toassign“3”,pressthe“3”buttonontheremotecontrol.

 NoIDmeansthatalltheprojectorscanbeoperatedtogetherwithasingleremote

control.Toset“NoID”,enter“000”orpresstheCLEARbutton.

TIP:TherangeofIDsisfrom1to254.

4. ReleasetheIDSETbutton.

 TheupdatedCONTROLIDscreenwillbedisplayed.

NOTE:

• TheIDscanbeclearedinafewdaysafterthebatteriesarerundownorremoved.

• Accidentallypressinganyoneofthebuttonsoftheremotecontrolwillclearcurrentlyspecied

IDwithbatteriesremoved.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 151 152

No comments

NEC NP-UM351WI-TM User Manual Page 102