NEC NP-UM351WI-TM User Manual download pdf (Page 24)

2. Projecting an Image (Basic Operation)

 Connecting Your Computer/Connecting the Power Cord

1. Connectyourcomputertotheprojector.

This section will show you a basic connection to a computer. For information about other connections, see “6.

InstallationandConnections”onpage106.

 Connectthecomputercable(VGA)betweentheprojector’sCOMPUTERINterminalandthecomputer’sport(mini

D-Sub 15 Pin). Turn two thumb screws of both terminals to ﬁx the computer cable (VGA).

2. Connectthesuppliedpowercordtotheprojector.

 Firstconnectthesuppliedpowercord’sthree-pinplugtotheACINoftheprojector,andthenconnecttheother

plug of the supplied power cord in the wall outlet.

The projector’s power indicator will ﬂash for a few seconds and then will light red* (standby mode).

 *Thiswillapplyforbothindicatorswhen[NORMAL]isselectedfor[STANDBYMODE].SeethePowerIndicator

section.(→ page 128)

Makesurethattheprongsarefullyinsertedinto

boththeACINandthewalloutlet.

To wall outlet ←

CAUTION:

PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbuttonorifthe

ACpowersupplyisdisconnectedduringnormalprojectoroperation.

Becarefultohandletheprojector.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 151 152

No comments

NEC NP-UM351WI-TM User Manual Page 24