NEC NP901W User Manual download pdf (Page 128)

114

Setting ID to the Projector [CONTROL ID]

You can operate multiple projectors separately and independently with the same single remote control. To do so,

you have to assign an ID number to each projector.

CONTROL ID NUMBER .......Select a number from 1 to 254 you wish to assign to your projector.

CONTROL ID .......................Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID set-

ting.

NOTE: Your setting will not be affected even when [RESET] is done from the menu.

Using the Remote Control to change IDs

1. Press the ID SET button on the remote control.

The CONTROL ID screen will be displayed.

If the projector can be operated with the current remote control ID, the [ACTIVE] will be displayed. If the projec-

tor cannot be operated with the current remote control ID, the [INACIVE] will be displayed. To operate the inac-

tive projector, assign the ID by using the following procedure (Step 2).

2. Press one of 0 to 9 buttons while pressing and holding the ID SET button on the remote control.

The range of IDs is from 1 to 254.

To clear the ID:

Press the CLEAR button while pressing the ID SET button.

NOTE:

• Setting "0 (zero)" means to clear the ID.

• You cannot operate the projector using the remote control if the remote ID is not the same as the projector ID.

• No ID means that all the projectors can be operated together with a single remote control. To set "No ID", enter "000" or

press the CLEAR button.

3. Release the ID SET button.

The updated CONTROL ID screen will be displayed.

NOTE: The IDs can be cleared in a few days after the batteries are run down or removed.

6. Using On-Screen Menu

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 164 165

No comments

NEC NP901W User Manual Page 128