NEC NP901W User Manual download pdf (Page 129)

115

6. Using On-Screen Menu

[OPTIONS]

Setting Auto Adjust [AUTO ADJUST]

This feature sets the Auto Adjust mode so that the RGB image can be automatically or manually adjusted for noise

and stability. You can automatically make adjustment in two ways: [NORMAL] and [FINE].

OFF ........................

The RGB image will not be automatically adjusted.

You can manually optimize the RGB image.

NORMAL ................

Default setting. The RGB image will be automatically adjusted. Normally select this option.

FINE .......................

Select this option if ﬁne adjustment is needed. It takes more time to switch to the source than when

[NORMAL] is selected.

Enabling Auto Power On [AUTO POWER ON (AC)]

Turns the projector on automatically when the power cable is inserted into an active power outlet and the main

power switch is turned on. This eliminates the need to always use the POWER button on the remote control or pro-

jector cabinet.

To use the AUTO POWER ON (AC) function, you must ﬁrst press the main power switch to the position “On” before

plugging in the power cable.

Enabling Power Management [AUTO POWER OFF]

When this option is selected you can enable the projector to automatically turn off (at the selected time: 5min.,

10min., 20min., 30min.) if there is no signal received by any input.

Enabling High Speed Fan Mode [FAN MODE]

This option allows you to select three modes for fan speed: Auto mode, High speed mode, and High Altitude mode.

AUTO .....................

The built-in fans automatically run at a variable speed according to the internal temperature.

HIGH ......................

The built-in fans run at high speed.

HIGH ALTITUDE ..... The built-in fans run at a high speed. Select this option when using the projector at altitudes approximate-

ly 5500 feet/1600 meters or higher.

When you wish to cool down the temperature inside the projector quickly, select [HIGH].

NOTE:

• It is recommended that you select High speed mode if you use the projector non-stop for consecutive days.

• Using the projector at altitudes approximately 5500 feet/1600 meters or higher without setting to [HIGH ALTITUDE] can cause

the projector to overheat and the protector could shut down. If this happens, wait a couple minutes and turn on the projector.

• Using the projector at altitudes less than approximately 5500 feet/1600 meters and setting to [HIGH ALTITUDE] can cause the

lamp to overcool, causing the image to ﬂicker. Switch [FAN MODE] to [AUTO].

• Your setting will not be affected even when [RESET] is done from the menu.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 164 165

No comments

NEC NP901W User Manual Page 129