NEC Express5800/R120d-2E SR User's Guide download pdf (Page 79)

1. Installing Internal Optional Devices

Express5800/R120d-2E User’s Guide

Chapter 2 Preparations

1.13.3

Installation

Install a riser card to a PCI card in the following procedure.

Important

When installing a PCI card, make sure the connector of the card fits the

connector of the riser card.

Note

• Check the card type (low profile or full-height type) which respective riser card

supports and the type of PCI card to be installed.

• To install an extra battery for RAID Controller, refer to Chapter 2 (1.11 Extra

Battery for RAID Controller).

[Installing RAID Controller card in slot PCI #1A]

1. Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.

2. Remove the screw securing the rise

card. Hold the both ends of the riser

card and lift it off.

Note

Be careful not to contact with other parts.

3. Confirm the installation position with the reference to the table in (1.13.2 Supported cards and

available slots).

4. Remove the screw, and remove RAID

Controller bracket from the rise card.

Note

Keep the slot cover for future use.

Screw

RAID Controlller bracket

Screws

1 ... 78 79 80 ... 151

No comments

NEC Express5800/R120d-2E SR User's Guide Page 79