NEC Express5800/R120d-2E SR User's Guide download pdf (Page 82)

1. Installing Internal Optional Devices

Express5800/R120d-2E User’s Guide

Chapter 2 Preparations

(1) When using the optional controller (N8103-149/150/151)

For details, refer to the manual that comes with optional RAID Controller (N8103-149/150/151).

Important

You must avoid static electricity to work with the procedure below. For

details, refer to Chapter 2 (1.2 Anti-static Measures).

Note

• When installing an optional RAID Controller, start the BIOS Setup utility, select

PCI Configuration from the Advanced menu, and then make sure that the

parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.

• When connecting a RAID Controller, set the boot priority to 8th or higher in the

Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the

configuration menu for RAID Controllers cannot be launched.

[Installing optional PCI card in slot PCI #1B, 2B, 3B, 1C, or 2C]

1. Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations..

2. Remove the three screw securing the rise

card B. Hold the both ends of the riser

card B and lift it straight to remove.

Note

Be careful not to contact with other parts.

3. Confirm the installation position with the reference to the table in (1.13.2 Supported cards and available

slots).

4. Remove the blank cover from the rise card

(common to PCI slots #1B to 3B, 1C, and

2C) .

Note

Keep the blank cover for future use.

①

②

Screws

1 ... 81 82 83 ... 151

No comments

NEC Express5800/R120d-2E SR User's Guide Page 82