Nec M350X User Manual download pdf (Page 25)

2. Projecting an Image (Basic Operation)

 Connecting Your Computer/Connecting the Power Cord

1. Connectyourcomputertotheprojector.

This section will show you a basic connection to a computer. For information about other connections, see “6.

Installation and Connections” on page 104.

Connect the computer cable (VGA) between the projector’s COMPUTER 1 IN connector and the computer’s port

(mini D-Sub 15 Pin). Turn two thumb screws of both connectors to ﬁx the computer cable (VGA).

2. Connectthesuppliedpowercordtotheprojector.

First connect the supplied power cord’s three-pin plug to the AC IN of the projector, and then connect the other

plug of the supplied power cord in the wall outlet.

The projector’s power indicator will ﬂash for a few seconds and then will light orange* (standby mode).

The STATUS indicator will also light green*.

* This will apply for both indicators when [NORMAL] is selected for [STANDBY MODE]. See the Power Indicator

section.(→ page 127)

COMPUTER 1 IN

Makesurethattheprongsarefullyinsertedinto

both the AC IN and the wall outlet.

To wall outlet ←

CAUTION:

PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbuttonorifthe

ACpowersupplyisdisconnectedduringnormalprojectoroperation.

Usecautionwhenpickinguptheprojector.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 154 155

No comments

Nec M350X User Manual Page 25