Nec MT1035 User Manual download pdf (Page 18)

Using A Tabletop Or Cart

1. Place your LCD projector on a flat level surface at the optimal

distance from the screen or wall so you realize the size image you

want. (Avoid having bright room lighting or sun light directly on the

screen or wall where you'll be projecting the image.)

2. Connect the power cable, remove the lens cap and turn the projector

on. (If no input signal is available, the projector will display a

background image.)

3. Ensure that the projector is square to the screen.

4. Move the projector left or right to center the image horizontally on

the screen. (A)

5. To center the image vertically (B), lift the front edge of the projector

and press the buttons on the front of the projector, just above the

feet, to release the one-touch tilt feet. (There is approximately 10.5˚

of up and down adjustment for the front of the projector. )

INSTALLATION

6. If a trapezoidal distortion appears on the screen, use the KEY-

STONE button on the remote control or select Keystone from the

menu to correct the distortion.

If necessary, adjust the front or rear feet so that the lens surface is

parallel to the screen. If you use the projector with the screen tilted,

the picture will be distorted. Each of the rear feet height can be

changed up to 0.6" (4 mm).

7. Increase or reduce the size of the projected image by pressing the

"Zoom" (+) or (–) buttons on the remote control or top of the

cabinet.

(A) Top view

(B) Side view

screen

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 52 53

No comments

Nec MT1035 User Manual Page 18