Nec MultiSync MT600 User Manual download pdf (Page 15)

• Supports most IBM VGA, S-VGA (pseudo), Macintosh or any

other RGB signals within a horizontal frequency range or 15 to

40 kHz and a vertical frequency range of 50 to 75 Hz. This

includes NTSC, PAL, SECAM, and M-NTSC standard video

signals.

Note: Composite video standards are as follows:

NTSC: U.S. TV standard for video in U.S.

and Canada.

PAL: TV standard used in western Europe

SECAM: TV standard used in France and

Eastern Europe

M-NTSC: (modified-NTSC)-result of converting

a video in the SECAM standard to

the NTSC standard

INTRODUCTION

• The remote control can be used with or without a cable, and

you can even use the remote to operate your PC or Macintosh

mouse wirelessly from across the room with the IR receiver

module.

• You can control your MultiSync MT600 LCD Projector with a

PC.

• The contemporary cabinet design is compact, easy to carry,

and complements any office, board room or

auditorium.

* Installing the MultiSync MT600 LCD Projector on the ceiling

must be done by authorized NEC technicians. Consult your

NEC dealer for more information.

This section helps you resolve problems you may encounter while setting up or using

your MultiSync MT600 LCD Projector.

Status Light Messages

Condition Status

OFF Normal

On Continually The projector lamp has exceeded

2000 hours of operation and

should be replaced.

Blinking Slowly Check the filter and clean it if necessary.

(Once a second)

Ensure that the filter panel is

installed properly.

Wait one minute before using the remote

control. Otherwise the lamp may not go on.

TROUBLESHOOTING

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

No comments

Nec MultiSync MT600 User Manual Page 15