Nec MultiSync MT600 User Manual download pdf (Page 24)

Lamp Usage This tells you how long the lamp has been in operation. It is

recommended that you replace a lamp after 2000 hours of service. To see

the time used, select this icon and press the (+) button. After you install a

new lamp, select this icon and press and hold the “Power On” button for ten

seconds to reset the lamp clock back to zero.

Reset Changes all adjustments to the factory preset levels for each source

individually. To activate, you must press the (+) button on the cabinet or

remote for at least two seconds. The adjustments that will be reset are

horizontal and vertical control (for the current image only), picture and fine

picture adjustment, brightness, contrast, color, tint, and sharpness.

**NOTE: The picture, fine picture and auto picture adjustment, and horizontal and

vertical position controls will not work with a video source.

OPERATION

This section describes how to set up your MultiSync MT600 LCD projector

and how to connect video and audio sources.

Setting Up Your MultiSync MT600 LCD Projector

Your MultiSync MT600 LCD Projector is simple to set up and use. But before

you get started, you must first:

1. Determine the image size

2. Set up a screen or select a non-glossy white wall onto which you can project

your image.

Carrying The LCD ProjectorAlways carry your LCD projector by the

handle. Ensure that the power cord and any other cables connecting to video

sources are disconnected before moving the projector. When moving the

projector or when it is not in use, cover the lens with the lens cap.

Selecting A Location The further your LCD projector is from the screen or

wall, the larger the image. The minimum size the image can be is approxi-

mately 20” (0.5m) measured diagonally when the projector is roughly 3.28 feet

(1.0m) from the wall or screen. The largest the image can be is 300” (7.6m)

when the projector is about 39 feet (12m) from the wall or screen.

INSTALLATION

Pull down

Carrying handle

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Nec MultiSync MT600 User Manual Page 24