NEC Express5800/R110d-1E Installation Guide download pdf (Page 44)

♦In case of key-in failure on the Remote Console

 During DOS boot or access to the removable media immediately after the managed server's po wer switch

is turned ON, data ca nnot be keyed in from th e remote console or th e keyed data display may be delay

ed.

 Remote Console is reali zed by using the Serial Over LAN (SOL) function of the IPMI confo rmity and the

Serial Redirection function of BIOS.

Data cannot be keyed in from the Remote Console when the firmware(BIOS and so o n) or the software r

equires the k ey code that VT100 terminal emulator (the hyper-terminal and so o n) can't control.

Refer to the document of ea ch firmware or software for the d etails.

♦RAID EzAssist Configuration Utility

To operate RAID EzAssist for a SOL-i ncompatible managed server from the CUI re mote console via LAN, set

the item " Console Redirection" to "Disable" on the BIOS Setup Ut ility screen, re boot the s ystem, and th en boo

t the RAID Ez Assist Configuration Utility.

♦Power management

 If you set the value o n the managed server which does not support power management, you cannot put

back the v alue to "u nsetting". Set "zero" t o each value, it is acce pted as "uns etting".

 The electric p ower value might not n ecessarily reach even the v alue of Po wer Cap value.

The electric power control lowers the power consumption of the s ystem by lowering the fr equency of CPU

/ Memory.

When CPU / Memory Throttling value reaches 100%, the electric power value doesn't fall an y more.

♦CPU blade auto registration

When "Check Connection" of "CPU b lade auto registration" was failed. You can execute "Check Connection" o

n "Server Pr operties" - "Connection Setting".

If a specified IP address is set from a CPU blade to another CPU blade during "CPU blade auto registration"

process (ex. when you replace CPU blade and execut e "CPU b lade auto registration"), NEC ESMPRO Mana

ger may not be able to connect the CPU blade beca use old in formation remains in the ARP table on the ma

nager server. Wait for a fe w minutes and try the " Check Connection".

♦Coexistence of NEC ESMPRO Manager with DianaScope Agent or NEC ESMPRO

Agent Extension on the same server

If the managed server is installed Advanced Remote M anagement Card or E XPRESSSCOPE Engine series (th

e BMC uses exclusive LAN port (m anagement LAN port)), NEC ESM PRO Manager can m anage the server its

elf installed. It th e managed server is in stalled BMC that u ses the standard LAN port, N EC ESMPRO Manage

r cannot manage the ser ver itself installed. It is possib le only to i nstall NEC ESM PRO Manager and Di anaSco

pe Agent or NEC ESMPRO Agent Extension on the same server. But the communication with BMC on the se

rver is p revented by local loopback function of OS and the BMC cannot receive any p ackets from the NEC E

SMPRO Manager.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 73 74

No comments

NEC Express5800/R110d-1E Installation Guide Page 44