NEC Express5800/R120e-1M User's Guide download pdf (Page 122)

1. Turning on the Server

Express5800/R120e-1M User’s Guide

122

Chapter 3 Setup

Turning on the Server

Pressing POWER Switch at the front of the server turns on the server.

Turn on the server by using the following procedure.

Tips

• Do not power on the server before amber POWER LED is unlit.

• Wait for at least 30 seconds before turning on the server after turning off the

server.

1. Turn on the peripheral devices and display unit.

Note

If the power cord is connected to power control system such as an Uninterruptible

Power Supply (UPS), make sure that the power control system is turned on.

2. Remove Front Bezel.

3. Press POWER Switch at the front of the server.

POWER LED is turned on green and after a while, logo appears on the display.

Important

Do not connect or disconnect USB device while POST is running.

While logo is being displayed, the self-diagnostic program (POST) runs and diagnoses the hardware. For

details, see Chapter 3 (1.1 POST).

POWER Switch

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 137 138

No comments

NEC Express5800/R120e-1M User's Guide Page 122