NEC Express5800/R120e-1M User's Guide download pdf (Page 92)

1. Installing Internal Optional Devices

Express5800/R120e-1M User’s Guide

Chapter 2 Preparations

1.13.5

Installing RAID Controller

This section describes how to install an optional RAID Controller to the slot dedicated to RAID Controller.

(1)

When using the optional RAID controller (N8103-172/173/174)

For details, see the manual that comes with optional RAID Controller (N8103-172/173/174).

Important

• You must avoid static electricity to work with the procedure below. For

details, see Chapter 2 (1.2 Anti-static Measures).

• Do not change the mode to hibernate while building a RAID System.

Note

• When installing an optional RAID Controller, start the BIOS Setup utility, select

PCI Configuration from the Advanced menu, and then make sure that the

parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.

• When connecting a RAID Controller, set the boot priority to 8th or higher in the

Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the

configuration menu for RAID Controllers cannot be launched.

Take the following procedure to install RAID Controller (N8103-172/173/174).

1. See steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.

2. Remove the two screws and remove PCI

riser card.

3. Remove the support bar.

4. Remove the two screws from RAID

Controller, and remove PCI bracket.

5. Remove the two screws from server

chassis, and remove RAID Controller

bracket.

6. Attach the RAID Controller bracket to

RAID Controller with two screws you

have removed in Step 4.

7. Insert RAID Controller into the slot dedicated to RAID Controller.

Ports 4-7

Ports 0-3

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 137 138

No comments

NEC Express5800/R120e-1M User's Guide Page 92