NEC Express5800/R120e-1M User's Guide download pdf (Page 90)

1. Installing Internal Optional Devices

Express5800/R120e-1M User’s Guide

Chapter 2 Preparations

1.13.3

Installation

Install a riser card to a PCI card in the following procedure.

Important

When installing a PCI card, make sure the connector of the board fits the

connector of the riser card.

Note

• Check the board type (Low Profile or Full Height) which respective riser card

supports and the type of PCI card to be installed.

• When installing an extra battery for RAID Controller or FBU, see Chapter 2

(1.11 Extra Battery / Flash Backup Unit for RAID Controller).

1. See steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.

2. Remove the screw securing the PCI riser

card. Hold the both ends of the PCI riser

card and lift it off.

3. Confirm the installation position with the reference to the table on 1.14.2 Supported boards and

available slots.

4. Remove the screw from the PCI riser

card and remove the blank cover.

Note

Keep the removed blank cover for future use.

5. Install a PCI card to the PCI riser card.

When installing the card, position the

terminal part of the PCI card to the PCI

riser card slot and insert it.

Important

Do not touch the terminal part of riser card or PCI card and the signal pins

of electric parts installed on the board. Installing boards with dirt or oil can

cause malfunction.

Note

• Make sure that the head of a PCI card bracket is seated into the fixed slot.

• Depending on type of PCI cards, the terminal part of the PCI card may be too

large to fit in the connector.

• If you have trouble installing the card, remove the card once and try again. If you

apply excessive pressure on the card, a PCI card or riser card might break.

PCIe #1B

Full Height side

PCIe #1C

Low profile side

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 137 138

No comments

NEC Express5800/R120e-1M User's Guide Page 90