NEC MA4000 User Manual download pdf (Page 44)

4-10 Setting Up Infrastructures

MA4000 Expense Management Cable Management User Guide - Issue 1

Setting Up the Cabling Infrastructure

Once the geographical infrastructure is set up using the SETUP menu

on the Cable Management Main Page, you must click Launch

Application on the Main Page and open the Cable Management

application to set up the cabling infrastructure.

While many elements of cabling infrastructure can be added at any time

after the geographical infrastructure is set up, Faceplates and

Termination Hardware should be set up first. Faceplates are usually

attached to a Work Area; Termination Hardware is placed in some type

of Telecommunication Space.

Termination Hardware

Termination hardware for all cabling infrastructure is easily set up. Cable

Management makes it simple to locate termination hardware when you

need to move cabling; it's also easy to track ports/positions and how

each is being used.

Before adding Termination Hardware, the space where it resides must

be set up. Termination Hardware should be placed in an appropriate

Telecommunication Space: a Consolidation Point, Entrance Room,

Handhole, Manhole, Termination Closet, Closet Point, or Utility Pole.

Termination hardware must be in place before backbone or asset

hardware can be connected or linked. See

Adding Termination

Hardware.

Adding Termination Hardware

As long as you have set up a Telecommunication Space (see “Adding an

Outdoor Space” on page 4-7 or “Removing an Outdoor Space” on

page 4-8, “Adding a Building” on page 4-3 or “Removing a Building” on

page 4-4, or “Adding an Indoor Space” on page 4-5 or “Removing an

Indoor Space” on page 4-6), you can place termination hardware in it.

Step 1 Click Launch Application on the Cable Management home page. On

the Navigator Tree, highlight the Telecommunication Space where you

want to add termination hardware.

Step 2 Select Termination Hardware in the List View drop-down field (upper

right pane) of the Cable Management window. The Termination HW Info

and Port/Pos. Details tabs appear in the Detail View (lower right pane).

Step 3 Click the List View Add button.

Step 4 Enter the ID designation-a unique value by which you will identify this

piece of termination hardware.

Step 5 Select a Termination Type from the drop-down list.

Step 6 In the Cross Connect Hardware Type frame, enter the following: PIN

Config, Cat. Rating, Term Type, Manufacturer, and Part #.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 73 74

No comments

NEC MA4000 User Manual Page 44