NEC Express5800/120Lh User's Guide download pdf (Page 147)

Installing and Using Utilities 6-9

NEC EXPRESSBUILDER for DOS-based with Remote Console

This subsection describes the procedures for using NEC EXPRESSBUILDER for DOS-based with

remote console.

NEC EXPRESSBUILDER contains the remote console feature that allows the system administrator

to set up the server from the management workstation (management PC) via the network or the

server's COM B (serial) port.

IMPORTANT:

 Do not use this feature on any other computer than the server, or

on any other server obtained without the NEC

EXPRESSBUILDER. Doing so may cause a failure of the

server.

 When a keyboard is connected to the server, the remote console

feature is disabled. The NEC EXPRESSBUILDER determines

that the server has a console. (Nothing is displayed on the

management PC.)

 If you fail to configure the disk array controller N8103-80F or 81F

from the remote console, try again using the server console.

 The system may fail to operate with the transfer rate of 115.2 Kbps

for serial console redirection. Specify any other transfer rate than

115.2 Kbps.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 313 314

No comments

NEC Express5800/120Lh User's Guide Page 147