NEC Express5800/120Lh User's Guide download pdf (Page 47)

General Description 2-21

4. POST displays SCSI ID numbers used by the connected SCSI devices on the screen.

5. After a few seconds, POST displays the following message prompting you to launch the

BIOS setup utility, SETUP, stored in the system memory of the server. This message

appears at bottom left on the screen.

Press <F2> to enter SETUP

Launch the BIOS setup utility when you need to change the settings to meet the

requirements for the server. As long as the above message is not displayed with an error

message, you don't have to launch the utility. (Ignore the message. POST will

automatically proceed.)

To launch the SETUP utility, press F2 while the above message is displayed. See

Chapter 4 for setup and parameters.

The server automatically restarts POST all over again when you exit the SETUP utility.

6. If the server has an optional disk array controller installed, POST displays the message

prompting you to launch the RAID configuration utility and the disk array BIOS setup

utility.

Refer to the manual supplied with the disk array controller for detail instructions.

POST will automatically proceed a few seconds later.

7. If you set a password using the BIOS setup utility, SETUP, the password entry screen

appears upon successful completion of POST.

Up to three password entries will be accepted. Three incorrect password entries disable

the server to boot. In such a case, turn off the power and wait about ten seconds before

turning on to boot the server.

IMPORTANT: Do not set a password before installing an OS.

8. The OS starts when POST completes.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 313 314

No comments

NEC Express5800/120Lh User's Guide Page 47