NEC Express5800/120Lh User's Guide download pdf (Page 223)

Upgrading Your Server 9-11

Installation

If installing new drives, follow an installation scheme starting with the bottom-most drive.

Fill the bays bottom-to-top.

Install a hard disk in the following procedure. A hard disk may be installed in any other slot in the

similar procedure.

NOTE: Hard disks can be installed or removed from the server only

by opening the front door. In the disk array configuration, hard disks

may be installed or removed with the power of the server being on.

IMPORTANT: In the disk array configuration, hard disks configuring

a specific pack should have the same specification including the

capacity.

1. See the section "Preparing for Installation and Removal" described earlier to prepare (in

other than the disk array configuration).

2. Release the lock of the front door by using the security key to open the front door.

3. Check the slot in which the hard disk is installed.

There are six slots. The SCSI IDs are defined depending on the locations of the slots

(SCSI ID0 to SCSI ID5 from bottom to top).

4. Remove the dummy tray.

IMPORTANT:

 Keep the dummy tray carefully.

 To maintain the cooling effect in the server, install the dummy tray

in the vacant slot of the disk bay.

1 2 ... 218 219 220 221 222 223 224 225 226 227 228 ... 313 314

No comments

NEC Express5800/120Lh User's Guide Page 223