Upgrading Your Server 9-33
6. Insert the board into the front retention mechanism and rear guide rails. Carefully push the
board until it engages and fully seats in the slot connector.
IMPORTANT: If the board cannot be installed easily, remove the
board once and then reinstall it. Excess force added to the board may
cause the board to be broken.
7. Fix the board with a screw removed in Step 4.
8. Reinstall the removed components.
9. Turn on the power of the server. Then make sure that any error message does not appear
in POST.
If an error message appears, write down the message and review the error message list in
Chapter 8.
10. Start the BIOS Setup Utility to set the "Reset Configuration Data" in the "Advanced"
menu to "Yes".
This is required to update the hardware configuration information. See Chapter 4 for
details.
Removal
Remove the board in the reverse procedure of the installation. Then install the additional slot
cover.
Guide rail
Comments to this Manuals