Nec M350X User Manual download pdf (Page 96)

5. Using On-Screen Menu

SelectingCommunicationSpeed[COMMUNICATIONSPEED]

ThisfeaturesetsthebaudrateofthePCControlport(D-Sub9P).Itsupportsdataratesfrom4800to38400bps.The

defaultis38400bps.Selecttheappropriatebaudrateforyourequipmenttobeconnected(dependingontheequip-

ment,alowerbaudratemayberecommendedforlongcableruns).

NOTE:Yourselectedcommunicationspeedwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

SettingIDtotheProjector[CONTROLID]

YoucanoperatemultipleprojectorsseparatelyandindependentlywiththesingleremotecontrolthathastheCONTROL

IDfunction.IfyouassignthesameIDtoalltheprojectors,youcanconvenientlyoperatealltheprojectorstogether

usingthesingleremotecontrol.Todoso,youhavetoassignanIDnumbertoeachprojector.

CONTROL ID NUMBER ��Select a number from 1 to 254 you wish to assign to your projector�

CONTROL ID ��Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID set-

ting�

NOTE:

• When[ON]isselectedfor[CONTROLID],theprojectorcannotbeoperatedbyusingtheremotecontrolthatdoesnotsupport

theCONTROLIDfunction.(Inthiscasethebuttonsontheprojectorcabinetcanbeused.)

• Yoursettingwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

•PressingandholdingtheENTERbuttonontheprojectorcabinetfor10secondswilldisplaythemenuforcancelingtheControl

ID.

AssigningorChangingtheControlID

1. Turnontheprojector.

2. PresstheIDSETbuttonontheremotecontrol.

The CONTROL ID screen will be displayed.

If the projector can be operated with the current remote control ID, the [ACTIVE] will be displayed. If the projector

cannot be operated with the current remote control ID, the [INACTIVE] will be displayed. To operate the inactive

projector, assign the control ID used for the projector by using the following procedure (Step 3).

3. PressoneofnumerickeypadbuttonswhilepressingandholdingtheIDSET

buttonontheremotecontrol.

Example:

To assign “3”, press the “3” button on the remote control.

No ID means that all the projectors can be operated together with a single remote

control. To set “No ID”, enter “000” or press the CLEAR button.

TIP:TherangeofIDsisfrom1to254.

4. ReleasetheIDSETbutton.

The updated CONTROL ID screen will be displayed.

NOTE:

•TheIDscanbeclearedinafewdaysafterthebatteriesarerundownorremoved.

•Accidentallypressinganyoneofthebuttonsoftheremotecontrolwillclearcurrentlyspecied

IDwithbatteriesremoved.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 154 155

No comments

Nec M350X User Manual Page 96