Nec MT 1020G /820G User Manual download pdf (Page 14)

E – 14

Using A Tabletop Or Cart

1. Place your LCD projector on a flat level surface at the

optimal distance from the screen or wall so you realize

the size image you want. (Avoid having bright room

lighting or sun light directly on the screen or wall where

you'll be projecting the image.)

2. Connect the power cable, remove the lens cap and turn

the projector on. (If no input signal is available, the

projector will display a background image.)

3. Ensure that the projector is square to the screen.

4. Move the projector left or right to center the image hori-

zontally on the screen. (A)

5. To center the image vertically (B), lift the front edge of

the projector and press the buttons on the front of the

projector, just above the feet, to release the one-touch tilt

feet. (There is approximately 10.5˚ of up and down ad-

justment for the front of the projector. When you need to

set the projector at 10.5° projection angle or more, use

the lift kit that is supplied.)

6. To fine tune the image's position vertically on the screen,

rotate each front foot.

7. Increase or reduce the size of the projected image by

pressing the "Zoom" (+) or (–) buttons on the remote

control or top of the cabinet.

FOCUS

ZOOM

ADJUST

ENTER

SELECT

POWER

ON/OFF

STATUSPUSH

(A) Top view

(B) Side view

Screen

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

No comments

Nec MT 1020G /820G User Manual Page 14