Nec MT1035 User Manual download pdf (Page 13)

INTRODUCTION

5 RGB Input 2 Connector (Mini D-Sub 15 pin)

Connect a Macintosh or compatible computer here using the signal

cable and the monitor adapter that is supplied. Or connect your PC

or RGB equipment such as IBM or compatible computers. Use the

signal cable that is supplied to connect to a PC.

RGB 2 Audio Input Mini Jack

This is where you connect a second RGB audio output from a

computer or another RGB source.

6 PC Control Port

Use this port to connect your PC to control the MultiSync MT1035

Projector. This enables you to use your PC and serial communica-

tion protocol to control the projector. If you are writing your own

program, command references are on pages 99 to 102.

A cap is put on the port at the factory. Remove the cap when using

the port.

7 Mouse Output Port

Use this port to operate your computer’s mouse functions from the

NEC MultiSync MT1035 remote control. When your computer is

connected here, the remote sensors on the LCD projector cabinet

will receive your mouse commands.

8 Remote Control Jack

Connect your remote control cable here for wired operation.

9 Built-in Security Slot ( )

This security slot supports the MicroSaver

Security System.

MicroSaver

is a registered trademark of Kensington Microware

Inc. The logo is trademarked and owned by Kensington

Microware Inc.

PC CONTROL MOUSE OUTPUT

REMOTE

CONTROL

INPUT

AUDIORGB INPUT 2

AUDIORGB INPUT 1

AUDIORGB MONITOR OUTPUT

RL/MONO

INPUT AUDIOS–VIDEO

RL/MONO

INPUT AUDIOVIDEO

678

AC IN

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 52 53

Comments to this Manuals

No comments

Nec MT1035 User Manual Page 13

Comments to this Manuals

Related products and manuals for Projectors Nec MT1035