NEC Express5800/120Lh User's Guide download pdf (Page 85)

Configuring Your Server 4-19

Exiting the Utility

To exit the utility, press Esc until a message prompts you to exit (if you changed any setting, you are

prompted to save the changes before you exit).

Configure/View SCSI Controller Settings

The Configure/View Host Adapter Settings has the following menu items and parameters. Read

descriptions to select a correct parameter for each menu item.

SCSI Bus Interface Definitions

To set three menu items under "SCSI Bus Interface Definitions", select a menu item with the cursor

keys (↓ or ↑) and press Enter to fix the item. Use the cursor keys (↓ or ↑) for parameter selection.

The following table lists menu items, available parameters, and descriptions.

Menu item Parameter Description

SCSI Controller ID 0 - [7] - 15 Select "7".

SCSI Controller Parity [Enabled]

Disabled

Select "Enabled".

SCSI Controller

Termination

[Enabled]

Disabled

Enable or disable the SCSI termination.

Select "Enabled".

[ ]: Factory-set

Additional Options

To set three menu items under "Additional Options", select a menu item with the cursor keys (↓ or

↑) and press Enter to display its submenu. Then, select a submenu item with the cursor keys (↓ or

↑) and press Enter to fix the item. Use the cursor keys (↓ or ↑) for parameter selection.

 Boot Device Configuration

Move the cursor onto "Boot Device Configuration" and press Enter to display the

submenu. The Boot Device Configuration submenu allows you to select the device

connected to the channel A or B as a boot device. Always select "AIC-7902 A".

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 313 314

No comments

NEC Express5800/120Lh User's Guide Page 85